Class 10 Science Chapter 12 Magnetic Effects of Electric Current NCERT Solutions

Complete, step-by-step solutions to all 13 in-text questions and every question in the Chapter 12 “Magnetic Effects of Electric Current” exercises, exactly as worded in the NCERT English edition. Try working out the answer yourself first, then check it against this one.

A In-text Questions

The question boxes printed inside the chapter, after the sections they test, answered first in book order. The end-of-chapter exercises follow below.

Question after Section 12.1

Question 1

Q. Why does a compass needle get deflected when brought near a bar magnet?

Answer: A compass needle is itself a small bar magnet, with a north pole and a south pole. A bar magnet produces a magnetic field in the region around it. When the compass is brought near, the field exerts forces on the poles of the needle (like poles repel, unlike poles attract), so the needle turns and gets deflected until it lines up along the magnetic field at that point.

Questions after Section 12.2.2

Question 1

Q. Draw magnetic field lines around a bar magnet.

Answer: Draw the bar magnet with its north (N) and south (S) poles marked. Around it, draw smooth closed curves that come out of the N pole, curve round outside the magnet and enter the S pole; inside the magnet the same lines run from the S pole back to the N pole. Put arrows on the lines pointing from N to S outside the magnet. Draw the lines crowded together near the poles, where the field is strongest, and farther apart away from the magnet. No two lines should cross. (This is the pattern of Fig. 12.4, obtained in Activity 12.3 by tracing with a compass.)

Magnetic field lines around a bar magnetDiagram: magnetic field lines around a bar magnet

Question 2

Q. List the properties of magnetic field lines.

Answer:
(i) Outside a magnet, field lines emerge from the north pole and merge at the south pole; inside the magnet they run from the south pole to the north pole. So magnetic field lines are closed curves.
(ii) The direction of a field line at a point is the direction in which a north pole of a compass needle placed there moves.
(iii) The relative strength of the field is shown by the closeness of the field lines: the field is stronger where the lines are crowded (near the poles).
(iv) No two field lines cross each other.

Question 3

Q. Why don’t two magnetic field lines intersect each other?

Answer: If two field lines crossed, then at the point of intersection there would be two directions of the magnetic field, and a compass needle placed there would have to point in two directions at the same time. This is not possible, so no two field lines intersect.

Questions after Section 12.2.4

Question 1

Q. Consider a circular loop of wire lying in the plane of the table. Let the current pass through the loop clockwise. Apply the right-hand rule to find out the direction of the magnetic field inside and outside the loop.

Answer: Hold each small section of the loop in the right hand with the thumb along the clockwise current; the curled fingers give the direction of the field lines. For every section, the fingers point into the table (downward) on the inner side of the wire and out of the table (upward) on the outer side. So, seen from above, the magnetic field inside the loop is perpendicular to the table and directed into it, and the field outside the loop is perpendicular to the table and directed out of it.

Question 2

Q. The magnetic field in a given region is uniform. Draw a diagram to represent it.

Answer: A uniform magnetic field has the same strength and the same direction at every point. It is drawn as parallel straight field lines, equally spaced, all carrying arrows pointing the same way (for example, from left to right). Equal spacing shows equal strength everywhere; the parallel arrows show the same direction everywhere. (The field inside a long current-carrying solenoid is an example of a uniform field.)

Uniform magnetic field: parallel, equally spaced lines in the same directionDiagram: a uniform magnetic field

Question 3

Q. Choose the correct option. The magnetic field inside a long straight solenoid-carrying current (a) is zero. (b) decreases as we move towards its end. (c) increases as we move towards its end. (d) is the same at all points.

Answer: (d) is the same at all points. The field lines inside a long solenoid are parallel straight lines, which shows that the magnetic field is the same at all points inside it, that is, the field is uniform.

Questions after Section 12.3

Question 1

Q. Which of the following property of a proton can change while it moves freely in a magnetic field? (There may be more than one correct answer.) (a) mass (b) speed (c) velocity (d) momentum

Answer: (c) velocity and (d) momentum. A moving charged particle in a magnetic field experiences a force at right angles to its motion. This force changes the direction of motion of the proton, so its velocity (which includes direction) changes, and so does its momentum (mass × velocity). The force does not change how fast it moves, so its speed stays the same, and its mass does not change.

Question 2

Q. In Activity 12.7, how do we think the displacement of rod AB will be affected if (i) current in rod AB is increased; (ii) a stronger horse-shoe magnet is used; and (iii) length of the rod AB is increased?

Answer: The displacement of the rod is caused by the force exerted on it by the magnetic field, and this force is greater when the current is greater, the field is stronger, and a greater length of the rod lies in the field. So the displacement of rod AB will increase in all three cases: (i) when the current is increased, (ii) when a stronger horse-shoe magnet is used, and (iii) when the length of the rod AB is increased.

Question 3

Q. A positively-charged particle (alpha-particle) projected towards west is deflected towards north by a magnetic field. The direction of magnetic field is (a) towards south (b) towards east (c) downward (d) upward

Answer: (d) upward. A moving positive charge is equivalent to a current in its direction of motion, so the current is towards the west. Apply Fleming’s left-hand rule: point the middle finger west (current) and the thumb north (force, the direction of deflection). The forefinger, which gives the field, then points vertically upward.

Questions after Section 12.4

Question 1

Q. Name two safety measures commonly used in electric circuits and appliances.

Answer: (i) An electric fuse connected in series in the circuit, which melts and breaks the circuit when the current becomes too large (overloading or short-circuiting). (ii) Earthing: the metallic body of an appliance is connected to the earth wire, so that any leakage of current goes to the earth and the user does not get a severe electric shock.

Question 2

Q. An electric oven of 2 kW power rating is operated in a domestic electric circuit (220 V) that has a current rating of 5 A. What result do you expect? Explain.

Answer: Current drawn by the oven, I = P/V = 2000 W / 220 V ≈ 9.1 A. This is much more than the 5 A current rating of the circuit, so the circuit is overloaded. The excessive current heats the wires, and the fuse in the circuit will melt (blow) and break the circuit, so the oven cannot be run on this circuit. Without a proper fuse, the overheated wiring could even catch fire.

Question 3

Q. What precaution should be taken to avoid the overloading of domestic electric circuits?

Answer: Too many appliances should not be connected to a single socket, and several high-power appliances (such as an oven, a heater and an air conditioner) should not be switched on in the same circuit at the same time. High-power appliances should be run on the separate 15 A power circuit, and every circuit should be protected by a fuse of the proper current rating.

B End-of-chapter Exercises

Exercises
  1. 1 markWhich of the following correctly describes the magnetic field near a long straight wire?
    (a) The field consists of straight lines perpendicular to the wire.(b) The field consists of straight lines parallel to the wire.(c) The field consists of radial lines originating from the wire.(d) The field consists of concentric circles centred on the wire.
  2. 1 markAt the time of short circuit, the current in the circuit:
    (a) reduces substantially.(b) does not change.(c) increases heavily.(d) varies continuously.
  3. 2 marksState whether the following statements are true or false. (a) The field at the centre of a long circular coil carrying current will be parallel straight lines. (b) A wire with a green insulation is usually the live wire of an electric supply.
  4. 2 marksList two methods of producing magnetic fields.
  5. 1 markWhen is the force experienced by a current-carrying conductor placed in a magnetic field largest?
  6. 4 marksImagine that you are sitting in a chamber with your back to one wall. An electron beam, moving horizontally from the back wall towards the front wall, is deflected by a strong magnetic field to your right side. What is the direction of the magnetic field?
  7. 4 marksState the rule to determine the direction of a (i) magnetic field produced around a straight current-carrying conductor, (ii) force experienced by a current-carrying straight conductor placed in a magnetic field which is perpendicular to it, and (iii) current induced in a coil due to its rotation in a magnetic field.
  8. 2 marksWhen does an electric short circuit occur?
  9. 2 marksWhat is the function of an earth wire? Why is it necessary to earth metallic appliances?
Answer Key and Explanations
Q1-2: Multiple Choice
  1. (d) The field consists of concentric circles centred on the wire. Iron filings around a straight current-carrying wire always arrange themselves in this pattern, growing weaker (bigger circles) farther from the wire.
  2. (c) increases heavily. A short circuit happens when the live and neutral wires touch directly, causing the current to rise abruptly, which is why a fuse is needed to break the circuit quickly.
Q3: True / False
  1. (a) True. A long circular coil, wound close together, behaves like a solenoid: the field lines inside it run parallel to its length, so at its centre they are indeed parallel straight lines.
  2. (b) False. The wire with green insulation is the earth wire, used only as a safety connection to a buried earth plate. The live wire has red insulation.
Q4-5: Short Answer
  1. Two methods of producing a magnetic field: (i) using a permanent magnet (a bar magnet, for example), and (ii) passing an electric current through a conductor: a straight wire, a circular loop or a solenoid.
  2. The force is largest when the direction of the current in the conductor is exactly perpendicular (at right angles) to the direction of the magnetic field.
Q6: The Electron Beam Problem
  1. Answer: the magnetic field must point vertically downward.

    Set up directions from where you are sitting: the electron beam travels from the back wall towards the front wall, i.e. away from you: call this “north.” The beam is deflected to your right, which is “east.” Since an electron is negatively charged, the conventional current direction is opposite to the electron’s motion, i.e. towards the back wall, or “south.”

    Applying Fleming’s left-hand rule with the middle finger along the current (south) and the thumb along the force (east, the direction of deflection), the forefinger, which gives the field direction, must point vertically downward for the three directions to come out mutually perpendicular in the correct sense. So the magnetic field is directed vertically downward, from the ceiling towards the floor.

Q7: The Three Rules
  1. (i) Magnetic field around a straight current-carrying conductor: the right-hand thumb rule (also called Maxwell’s corkscrew rule): thumb along the current, curled fingers give the field direction.

    (ii) Force on a current-carrying straight conductor placed perpendicular to a magnetic field: Fleming’s left-hand rule: forefinger along the field, middle finger along the current, thumb gives the direction of the force.

    (iii) Current induced in a coil due to its rotation in a magnetic field: Fleming’s right-hand rule: forefinger along the field, thumb along the direction of motion of the conductor, middle finger then gives the direction of the induced current.

Q8-9: Short Answer
  1. A short circuit occurs when the live wire and the neutral wire come into direct contact with each other, usually because the insulation on one of them has worn away, or because an appliance has developed a fault. The current in the circuit then rises abruptly.
  2. Function of the earth wire: it connects the metal body of an appliance to a metal plate buried deep in the earth, providing a low-resistance path for any current that leaks onto the appliance’s body. Why appliances with a metal body must be earthed: without earthing, a current leak would raise the metal body to a dangerous potential, and anyone touching it could receive a severe electric shock. With earthing, the leaking current flows safely away to the earth instead, keeping the body’s potential equal to the earth’s.